The ZN086 adapter for ABPROG is used for establishing communication with a specific type of processors. This adapter is not a standalone tool, it is used in boot mode by directly soldering the wires to four points on the PCB. The adapter is then connected to the ABPROG and AVDI to complete the procedure.
Main functionalities:
Reading data from MC9S12 processors
Writing data from MC9S12 processors
Supported processors:
Unlocked MC9S12xxxxxxxxx processors
Pinout:
DB25 (Male) connector - used for connecting to ABPROG
4 wires 20 cm each as follows:
14pin - GND - black 0.25
21pin - +5v - red 0.25
11pin - RST - yellow 0.14
19pin - BKGD - green 0.14
These reading and writing functionalities are accessible via ABPROG Upgraded and Classic menus in the ABRITES software. AVDI
and active AMS
are required.
30 day return accepted on DEFECTIVE hardware only.
Please enter AVDI# in the notes section when checking out. This is required to complete the order processing.
User of these products accepts full legal responsibilities for proper usage. These products are intended for legal use only. ABRITES USA does not condone or accept any responsibility for misuse of it's products.
